Fix Loose Gears

Hold the motor and remove this bolt with a 3/16" hex wrench. Meade supplies this wrench, its the largest of the three that shipped with the mount. Once the bolt has been removed slide the motor down and remove it from the mount.

If the set screw is not visable rotate the gear until you can reach it with a .050" hex wrench and tighten it up.

Now tighten the gear set screw on the worm gear shaft. Again use a .050" hex wrench

After tightening the set screws up, replace the motor on the mount.
Make sure the gears mesh as in the photo and tighten the hex bolt that holds the motor on.